Site Navigation

Choose Language

iMac Intel 21.5" EMC 2308 RAM Installation

Replacing the RAM in the iMac 21.5" EMC 2308

  • Author: Dozuki System
  • Time estimate: 5 minutes
  • Difficulty: Easy

Upgrade your RAM for an instant increase in speed.

Step 1 Access Door  ¶ 

Image 1/2: These screws will remain captive in the access door. Image 2/2: Remove the access door from your iMac.

Step 1 Access Door  ¶ 

  • Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.

  • These screws will remain captive in the access door.

  • Remove the access door from your iMac.

  • During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.

Step 2 RAM Installation  ¶ 

Image 1/1:

Step 2 RAM Installation  ¶ 

  • Use the sharp tip of a spudger to pull the black plastic RAM tabs out of the memory bay.

Step 3  ¶ 

Image 1/2: Grab the RAM chip by its edges and pull it straight out of its slot. Image 2/2: If two RAM chips are installed, repeat this process for the other chip.

Step 3  ¶ 

  • Pull the black plastic RAM tab away from your iMac to eject the RAM chip.

  • Grab the RAM chip by its edges and pull it straight out of its slot.

  • If two RAM chips are installed, repeat this process for the other chip.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

No comments.

Add Comment