Site Navigation

Choose Language

MacBook Pro 15" Unibody Mid 2009 RAM Installation

Upgrade your RAM for an instant increase in speed.

Step 1 Lower Case  ¶ 

Image 1/1: Seven 3 mm Phillips screws.

Step 1 Lower Case  ¶ 

  • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

Step 2  ¶ 

Image 1/2: Remove the lower case and set it aside.

Step 2  ¶ 

  • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

  • Remove the lower case and set it aside.

Step 3 RAM Installation  ¶ 

Image 1/2: These tabs lock the module in place and releasing them will cause the module to "pop" up.

Step 3 RAM Installation  ¶ 

  • Release the tabs on each side of the module by simultaneously pushing each tab away from the RAM.

  • These tabs lock the module in place and releasing them will cause the module to "pop" up.

  • After the RAM module has popped up, pull it straight out of its socket.

  • Repeat this process if a second RAM module is installed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

No comments.

Add Comment