Site Navigation

Choose Language

Introduction

Accessing the RAM in this computer is straightforward and requires minimal disassembly.

Tools

Parts

Remove the following ten screws securing the lower case to the upper case:
  • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

Add Comment

Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.
  • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

  • Remove the lower case and set it aside.

Add Comment

Release the tabs on each side of the module by simultaneously pushing each tab away from the RAM module. These tabs lock the module in place and releasing them will cause the module to "pop" up.
  • Release the tabs on each side of the module by simultaneously pushing each tab away from the RAM module.

  • These tabs lock the module in place and releasing them will cause the module to "pop" up.

  • After the RAM module has popped up, pull it straight out of its socket.

  • Repeat this process if a second RAM module is installed.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Dozuki System

Member since: 09/24/2009

276 Guides authored

0 Comments

Add Comment