MacBook Pro 15" Unibody Mid 2009 RAM Installation

Upgrade your RAM for an instant increase in speed.

Image #1

Step 1 Lower Case  ¶ 

  • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

Image #1

Step 2  ¶ 

  • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

  • Remove the lower case and set it aside.

Image #1

Step 3 RAM Installation  ¶ 

  • Release the tabs on each side of the module by simultaneously pushing each tab away from the RAM.

  • These tabs lock the module in place and releasing them will cause the module to "pop" up.

  • After the RAM module has popped up, pull it straight out of its socket.

  • Repeat this process if a second RAM module is installed.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the MacBook Pro 15" Unibody Mid 2009 category page.

Comments Comments are onturn off

No comments.